Dear colleagues,
I built a node configuration with ACID system and URI from DMKEngineering.
After the import of the ACID/Asterisk/app_rpt configuration from Allstarlink.org I connected the URI to my reg and install IAX client to the PC.
The system work well from IAX clent through URI to the reg - when I
send audio or voice from IAX client to the reg through URI the reg
transmit the audio very well and clear.
The problem is that I can not
send any audio signal from the REG to the IAX client. Practically the
audio from the REG go to the MIC_AC pin of URI and after that dropped
down.
Practically I have only one way audio communication: Iax client ->Asterisk-> app_rpt -> URI -> reg
Probably I use a wrong usbradio.conf configuration but have not idea where to start looking for the problem.
I red in the
mailing list content some similar cases and advices about URI MIC
interface problems and tried to use them but unfortunately without
success.
I will be very grateful for any advice how to resolve the problem.
73!
Alex
LZ1AZA
The configuration I use is the following:
URI hardware interface:
audio line output of the reg - to URI MIC_AC (pin 21)
microphone input of the REG - to LEFT_AC(pin 22)
PTT - to PTT pin of the URI (pin1)
the URI's usbradio.conf file look like this:
;
; Usbradio channel driver Configuration File
;
[general]
[usb27371]
hdwtype=0
rxboost=1
txboost=1
rxctcssrelax=1
txctcssdefault=100.0
rxctcssfreqs=100.0
txctcssfreqs=100.0
;rxctcssoverride=0
carrierfrom=dsp
ctcssfrom=dsp
rxdemod=flat
txprelim=yes
txlimonly=no
txtoctype=notone
txmixa=composite
txmixb=no
invertptt=0
duplex=1
rxondelay=0
rxnoisefiltype=0
eeprom=0
#includeifexists custom/usbradio.conf