Nope.

If I set pp2 = out0 I read about 100 ohms

If I set pp2 = out1 it reads open

Entering *8411 or *8401 yields no change. (from rpt.conf 8401=cop,61,pp2=0 8411=cop,61,pp2=1)

The node plays back 2 beeps

Watching the CLI I see --Hungup ‘Zap/pseudo-123418903’ (number changes each time)

Commands are being sent from IAXRPT and from a locally connected radio

Jamey

WR4JW

From: Harold (K7ILO) [mailto:k7ilo1@gmail.com]
Sent: Saturday, August 08, 2015 1:34 AM
To: 'Jamey Wright' <jamey.wright@charter.net>
Subject: RE: [App_rpt-users] I/O using parallel port

Follow this Jamey….. http://www.qsl.net/k0kn/irlptoallstar.html

Your info should be in either usbradio.conf or simpleusb.conf

Just read through it and you’ll get it.

I use this method also.

Harold

K7ILO

From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Jamey Wright
Sent: Friday, August 7, 2015 4:29 PM
To: app_rpt-users@ohnosec.org
Subject: [App_rpt-users] I/O using parallel port

Since I have the node computer here at house for a day or 2 instead of at the tower site I decided I would go ahead and configure the I/O for something I have in mind in the future. I seem to be having some issues though… When I enter *8401 from IAXRPT, I get back “beep beep” but I don’t see a state change with my DMM across pin 2 and ground

In BIOS, the parallel port is configured at address 378 and IRQ7 and in EPP mode.

I have this in the RPT.CONF:

[functions27981]

80=status,1

81=status,2

8401 = cop,61,pp2=0

8402 = cop,61,pp3=0

8411 = cop,61,pp2=1

8412 = cop,61,pp3=1

901=cop,33 ; Local telemetry output enabled

902=cop,34 ; Local telemetry output disabled

903=cop,35

And I have this in SIMPLEUSB.CONF:

; SimpleUSB configuration

;

[general]

pp2=out1

pp3=out0