Jeff Lavoie
[wqex694@wqex694.info] Wrote:
>I seem to have a problem
tuning the USB radio interface. Here'e what I get in the CLI.
>
>*CLI> radio tune
>Active radio interface
is [usb]
>Output A is currently
set to composite.
>Output B is currently
set to voice.
>Tx Voice Level currently
set to 500
>Tx Tone Level currently
set to 200
>Rx Squelch currently set
to 500
>Device String is 3-2
>Usage: radio tune
<function>
>
rxnoise
>
rxvoice
>
rxtone
>
rxsquelch [newsetting]
>
txvoice [newsetting]
>
txtone [newsetting]
>
auxvoice [newsetting]
>
save (settings to tuning file)
>
load (tuning settings from EEPROM)
>
>
All [newsetting]'s are values 0-999
>
>*CLI> radio tune
rxnoise
>tune rxnoise maxtries=12,
target=23000, tolerance=2000
>tries=0, setting=2,
meas=1
>tries=1, setting=16,
meas=1
>tries=2, setting=16,
meas=1
>tries=3, setting=16,
meas=1
>tries=4, setting=16,
meas=1
>tries=5, setting=16,
meas=1
>tries=6, setting=16,
meas=1
>tries=7, setting=16, meas=1
>tries=8, setting=16,
meas=1
>tries=9, setting=16,
meas=1
>tries=10, setting=16,
meas=1
>tries=11, setting=16,
meas=1
>DONE tries=12,
setting=1000, meas=1
>ERROR: RX INPUT ADJUST
FAILED.
>*CLI>
>
>
>
>
>
>
>I know I have audio
going into the device. When I made the modifications to the usb device, I
decided not to remove the >audio output jack so that I may use it for
testing purposes. So I plugged some speakers in, went into alsamixer, un->muted
the microphone, turned it up a little, and I had sound from the radio without
any problems. So why can't asterisk >hear the sound when tuning?
Have I forgotten to do something else before trying this?
>
>Jeff
Well I am getting the same thing except the Meas= is around
9-11 and the final Done line reads tries=12 setting=1000 measure=10
And I can’t get the usb fob to repeat!... however is
does decode DTMF in double… IE push the tone once and it shows up as
being decoded twice on the CLI… I am thinking I need to reinstall
this EVB setup I have been trying to get working!
Anyone have any ideas??
Best Regards,
Roger W4RFJ