This is a way to make the link persistent, in rpt.conf, set the following:

rpt.conf:970=ilink,13 ; Permanently connect specified link -- transceive

Then put in a start up macro in rpt.conf and you are set.

You do not have to use 970, tht is the sysop choice.

Keith
VA3YC

On 1/21/14 3:12 PM, "buck" <buck@thebghouse.org> wrote:


Hi,
 
We have 2 nodes connected over a microwave link. The link is very stable but occasionally the nodes disconnect due to network instability.
 
Can I change the retry counts or failure times between nodes?
 
Has someone written a script that run under cron to check and re-connect nodes that drop?
 
Thanks,
Birton, N6UG
 
Nodes:
27035
27283
28138
….
 
 

_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.

--
keith@goobie.org
Keith Goobie
Richmond Hill, ON, CANADA