[general] port = 667 ; buflen = 100 ; specifies the receiver buffer length in milliseconds. ; This parameter should be set to the maximum expected network latency, ; plus a little padding (100 milliseconds of padding is a good amount). ; The default is 500 milliseconds, ; Buffer length may be specified on a perstanza and per-client basis ; http://ohnosec.org/drupal/node/195. password = hytera ; password common to all clients utos = y ; Turn on IP TOS for Ubiquiti [1998] MAIN = pass1,master,transmit ; master,transmit,adpcm,nulaw,nodeemp,buflen=value,gpsid[=value] ; master - this client is the Master Timing source ; secret - password unique to this client ; (the RTCM client that is on the same LAN as the Asterisk server.) ; There can only be 1 Master Timing source per entire Asterisk server. ; transmit - this client is intended to have transmit audio sent to it and will have a transmitter connected to it. ; adpcm - this client is to be sent audio in ADPCM format, rather than Mulaw. ; nulaw - this client is to be sent audio in 4000 samples/second Mulaw (Nulaw, as we call it), rather than the standard 8000 samples/second. ; nodeemp - this client is not to perform de-emphasis of the receiver audio (This is only to be used with non-voting clients.) ; buflen=value - buffer length for this client only. ; gpsid[=value] - This specifies a gps identity to associate with the specified client (as referred in the /etc/asterisk/gps.conf file).; plfilter = y ; DSP high pass filter txctcss = 162.2 ; Transmit CTCSS frequency txctcsslevel = 0 ; Transmit CTCSS level ;txtoctype = phase ; Transmit tone control type: none,phase,notone ; none - CTCSS tone encoding with no hang time (default) ; phase - encode CTCSS and reverse phase (AKA "reverse burst") before unkeying TX ; notone - encode CTCSS and stop sending tone before unkeying TX (AKA "chicken burst") thresholds = 255,110=5 ; linger=6 ; ; streams = 67.215.233.178:1667 ; WM = rxwm