Robert,
Te stop hearing remote telemetry you just need to disable it.
Add these lines to your rpt.conf under the functions stanza.
[functions] it may read [functions28183]
901=cop,33 ; Local telemetry output enabled
902=cop,34 ; Local telemetry output disabled
903=cop,35 ; Local telemetry output timed Remote (when anybody connects/disconnects from xxxxx Only)
You can also put that into your startup script to stop it from ever happening.
[28183]
startup_macro=*903#
rxchannel = Radio/usb28183 ; Rx audio/ signaling channel
If you ever want to re-enable it, just do a *901
Thank you,
Fred McLean
AllStar 29503
832-948-5200
From: mike@midnighteng.com [mailto:mike@midnighteng.com]
Sent: Friday, January 17, 2014 7:23 PM
To: App_rpt-users@ohnosec.org
Subject: Re: [App_rpt-users] Telemetry Help
You have no control of announcements from other nodes you are connected to.
If you think about that, others telemetry is important to know if you are going to be connected to them. Otherwise, you could interfere with pending operations.
...mike/kb8jnm
-------- Original Message --------
Subject: [App_rpt-users] Telemetry Help
From: W2YMM <w2ymm1@gmail.com>
Date: Fri, January 17, 2014 5:37 pm
To: App_rpt-users@ohnosec.orgHello, I wanted to know if there is a way to shut off or limit announcements that I hear on my Allstar node.
When connected to a large hub I very often hear "Remote Already In This Mode" and I'll hear when stations connect and Disconnect from each other, or if a call fails.
I'd like to turn that off, but can't seem figure out where to do it.
I looked at the Telemetry section here http://ohnosec.org/drupal/node/102
but It doesn't look like anything on my node.. At least in /etc/asterisk/rpt.conf
Any help would be greatly appreciated.Thanks
Robert Prybyzerski JrW2YMM
631-960-1051
http://www.w2ymm.comAllstar 28183
_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users