Tom,
Did you get a chance to look at the included readme that was in the zip file?

Login: repeater
Passsword: allstarlink
SSH port: 22
User repeater has sudo privileges (sudo -s)

There may have been updates to the operating system and AllStarLink since this image was built.
Run the following commands after the first time you boot.

apt-get update
apt-get upgrade -y
reboot

at the # prompt run "asl-menu" to setup your node.

73, Steve N4IRS

On 3/22/2018 7:55 AM, TGundo 2003 wrote:
Good morning all- newbie to the project here, and I'm learning Linux at the same time. I have a tiny bit of Linux experience, but not enough at this point. Still trying to get all the basic commands down (too much DOS stuck in my head).

I managed to successfully download the latest DIAL image, put it on an SD card, and get my Pi2 to boot up. It prompted me to change the PW, which i did in the default repeater@repeater user. I also logged into root and changed that password.

The 2 current issues I have are:

1- I never had the "first run" prompts for the node config pop up, and from what I read on the wiki it should. Any thoughts?

2- I cannot seem to SSH either into the root or repeater user from putty. It rejects the connection. I am trying to use port 222. Any thoughts?

The user Repeater doesn't seem to have rights to install apps, i tried to get VIM per the instructions of another Ham, it wouldn't under the repeater user, but it did under the root user. Is that normal?

Thanks for any help, sorry for such basic questions!

Tom
W9SRV


_______________________________________________
App_rpt-users mailing list
App_rpt-users@lists.allstarlink.org
http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.