Are you running your TX audio to the flat input or mic input?

If you are running the mic input and not relying on the PL encoder on the radio and trying to send PL into the radio via mic, this will cause problems.

Be sure to use the flat TX input.. If not, then change the radio to encode PL and turn the PL off on the URI side.

Lu

KA4EPS

From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Tim Sawyer
Sent: Saturday, October 29, 2011 1:15 AM
To: app_rpt list
Subject: Re: [App_rpt-users] Female Voice too loud

Try simpleusb-tune-menu 

--
Tim
:wq

On Oct 28, 2011, at 8:33 PM, Jesse Royall wrote:

Female voice is too loud on the system. Sometimes she overides the PL tone and causes clipping.

Is there a way to turn her down? OR even a way to adjust the audio perimiters?

Running simpleusb setup. GM300. DMK.URI

No radio tune menu so I can't adjust the audio in simpleusb mode.

When running radio-tune-menu

Error parsing device parameters

Tried copying txmixaset=500 perimeter into the simpleusb.conf and no changes. Tried changing to lower value no change.

CLI error on simpleusb_tune_usb27978.conf 

cp simpleusb.conf simpleusb_tune_usb27987.conf and no changes

doubled checked the txmixaset=500 and added that again with no change.

Running outa ideas. 

_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users