Try commenting out the link2link=1 in rpt conf.

then reload the RPT conf.

Jon

If you have a tail on the sinplex mode then you dont need that. Its for connecting a node to a harware controller with full duplex and no tails or ids.

On 6/24/2013 1:46 PM, James Hill wrote:

On 24/06/2013 18:40, Jon Rorke wrote:

Since this is a half duplex radio, make sure you have duplex=1 in rpt.conf and in usbradio.conf you have duplex = 0.

If usbradio has duplex = 1 then it thinks you have a full duplex radio.
You need to tell usbradio it is half duplex.

Hi John,

usbradio.conf is duplex=0 - Always has been!

I've done a few more tests to rule out hardware (such as removing the USB wlan dongle, rebooting & running on a cable) but still no luck.

usbradio.conf contents are pasted below, for anyone that is interested:

;
; Usbradio channel driver Configuration File
;

[general]

[usb29681]

hdwtype=0
rxboost=1
txboost=1
rxctcssrelax=1
;#txctcssdefault=100.0
;#rxctcssfreqs=100.0
;#txctcssfreqs=100.0
;rxctcssoverride=0
carrierfrom=vox
ctcssfrom=no
rxdemod=speaker
txprelim=no
txlimonly=no
txtoctype=notone
txmixa=voice
txmixb=no
invertptt=0
duplex=0
rxondelay=0
rxnoisefiltype=0
eeprom=0

#includeifexists custom/usbradio.conf
_______________________________________________
App_rpt-users mailing list
App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users