Scott and others, just an FYI. Some people get caught by the active low signalling on the URI.

What I mean by that is the URI input lines like to see a signal that goes to ground. It doesn't care for input voltage applied but does care if the inputs are grounded.

This is true for active hi signals (signals that are normally ground then go hi when a signal is present) or active low (signal is hi then goes to ground when signal is present).

The COR and PL inputs are internaaly pulled hi and have dc blocking diodes to prevent over voltage damage.

So in some cases the voltage swing from the connected radio doesn't pull the lines to ground but does source a dc voltage change.

So depending on how the logic is set the URI may not see the change or may think the radio is receiving all the time and time out the node.

So for active low the "Corfrom" should be set for "usbinvert". For active hi signals the "corfrom" is set for "usb".

If it looks like the radio cant pull the COR to ground then an NPN  transistor can be employed to pull the line low.
It the transistor is used then the logic set for cor from should be changed to the opposite from above as the transistor inverts the logic.

hope this helps.

Jon vA3RQ





On 5/22/2017 6:30 AM, Scott Westerman wrote:
I was able to get the 820 up and running with this configuration.

Name is:         usb
Rx Level:        500
Rx no-delay:     0
Rx audio-delay:  0
Tx A Level:      500
Tx B Level:      500
preemphasis:     no
deemphasis:      yes
plfilter:        no
rxboost:         yes

PTT:             Active LOW
PTT status:      Un-Keyed

CTCSS (input):   CM108/CM119 Active HIGH
COS (input):     CM108/CM119 Active LOW
COS (test):      Un-Keyed
COS (composite): Un-Keyed

Hope this is helpful for those who may need the info.

Scott W. - W9WSW 


_______________________________________________
App_rpt-users mailing list
App_rpt-users@lists.allstarlink.org
http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.