----- Original Message -----
Sent: Tuesday, January 25, 2011 10:54
PM
Subject: RE: [App_rpt-users] manually
issue COP command?
never mind... that was just a dumb suggestion. I wasnt paying
attention fully.
sorry
From: telesistant@hotmail.com
To: yokshs@sbcglobal.net; app_rpt-users@ohnosec.org
Subject:
RE: [App_rpt-users] manually issue COP command?
Date: Tue, 25 Jan 2011
20:12:31 -0800
How about
rpt cmd 2211
cop 61 GPIO4=1
(since that's what would go in the line for a
DTMF function)
JIM
From: yokshs@sbcglobal.net
To: app_rpt-users@ohnosec.org
Date:
Tue, 25 Jan 2011 13:57:28 -0600
Subject: [App_rpt-users] manually issue COP
command?
Thanks for the reply.. I have these entries in
usbradio.conf:
pp3 = ptt
pp11 = cor
; pp10 =
in ; in, cor or ctcss
; pp12 =
in ; pins 10,12,13,15 are for
DTMF
; pp13 = in
; pp15 =
in
pp4=out0 ; pins 4,5,6 are AUX 1,2,3,
default off
pp5=out0
pp6=out0
My PTT and COS via the parallel port work
perfectly, but so far, the only success I've had controlling other
pins
has been by assigning them to PTT.
For example, as a test I set:
pp3 = ptt
pp4 = ptt
pp5 = ptt
pp6 = ptt
This keys all 4 outputs any time PTT is called
for. I just wanted to make sure that app_rpt could control those pins..
Besides that, I've had no success trying to use
COP 61 or 62 to control my pp4,5,6
I've tried the syntax you suggested:
rpt cmd 2211 cop 61 pp4=1
I've also tried every other thing I could
think of, including:
rpt cmd 2211 cop 61 pp4=1,0
rpt cmd 2211 cop 61 pp4=1.0,0
rpt cmd 2211 cop 62 pp4=32767
73.
Kyle
K0KN
--- Original Message ---
I've not played with this but my guess is...
You in usbradio.conf you should put this in the [usb] stanza:
pp2=out0 ; set parallel port pin 2 to low output.
Then this should change it to high:
CLI>rpt cmd 2211 cop 61 pp2=1
Jim or others please jump in here if I have it wrong.
--
Tim
:wq
_______________________________________________
App_rpt-users mailing list App_rpt-users@ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users