The nodes DO have to be connected even if
they’re on the same LAN I’ve found that they have to be connected
in order to pass commands from one to the other. I’m assuming yours are
public nodes, mine is different because they’re all private nodes except
for 28257.
K0JSC
From: Ken
[mailto:ke2n@cs.com]
Sent: Friday, September 21, 2012
12:10 PM
To: bdboyle@bdboyle.com;
app_rpt-users@ohnosec.org
Subject: Re: [App_rpt-users] ok...
you just have to wait 15-30 minutes after
restarting *either* of the systems
you can avoid the wait by putting the
explicit address (IP:port) in each other node's [nodes] stanza.
Asterisk checks the [nodes] list
before going to the registration server ... this is just like if you had some
internal or non-registering nodes (numbers less than 2000, for example) except
you include the port number.
Ken
-----Original
Message-----
From: Bryan D. Boyle <bdboyle@bdboyle.com>
To: app_rpt mailing list <app_rpt-users@ohnosec.org>
Sent: Fri, Sep 21, 2012 1:19 pm
Subject: [App_rpt-users] ok...
so...got it registered...and can connect between node connected on oneinternal server on iax port 4570 to another on iax port 4569...it showsup in the node list on the mother ship... However...using the cli command 'rpt fun node dtmf-function' betweenthem...nada. do I have to specify somewhere the proper ports@IP (ie 192.168.1.98:4569and vice versa) to get commands to pass between the servers? Sorry for what may seem bloody obvious... BB_______________________________________________App_rpt-users mailing listApp_rpt-users@ohnosec.orghttp://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users