Will, See below for things to try. Steve. Will wrote:

Right now I have asterisk installed and running app_rpt.c 0.75. The warning I recieving when I run asterisk is [2615]: app_rpt.c:10709 rpt_master: Did not specify ident for node 2059.

This is just a warning and will not prevent app_rpt from working. Set idrecording=|iw4wwm/r for a morse ID for now.

The problem is also indicated on the ARIB board with TX led (red) is on all time. With this check, CLI> core show channels, the out put is 0 active channels and 0 active calls.

This could be caused by several things: 1. Incorrect polarity on modular cable from FXS board to TX port on ARIB. Try a differenct cable which swaps the red (ring) and green (tip) conductors. 2. Receiver port on FXS board swapped with transmitter port. Try swapping the cables on both ports and see if the red LED goes off after a few seconds. 3. Incorrect COR polarity. Does changing the COR polarity switch on the ARIB cause the red led to extinguish?

With another check on the CLI> rpt stats 2059, I get all the information concerning the request.

I'm really in need of help and trying my best to understand how the system works. Any help would be highly be appreciated. Thanks.

Will / W4WWM

------------------------------------------------------------------------

_______________________________________________ App_rpt mailing list App_rpt@lists.illiana.net http://lists.illiana.net/mailman/listinfo/app_rpt