Thnaks Mark will take a look at this. Le lun. 23 juil. 2018 à 02:40, Mark Guibord <mark@micro-node.com> a écrit :

Pierre,

You will need the Microchip's PICkit3 In-Circuit Debugger/Programmer and the MPLAB IDE programming software. Both are available from MicroChip. https://www.microchip.com/Developmenttools/ProductDetails/PartNo/PG164130

This is a very helpful Wiki that will help get started. https://wiki.allstarlink.org/wiki/RTCM_Client

Mark Guibord

Micro-Node International

*From:* App_rpt-users [mailto:app_rpt-users-bounces@lists.allstarlink.org] *On Behalf Of *Pierre Martel *Sent:* Sunday, July 22, 2018 5:08 PM *To:* APP RPT *Subject:* Re: [App_rpt-users] DSPIC33FJ128GP802 programing

Forgot to say that I have acces to a chipkit3 (from a friend)

Le dim. 22 juil. 2018 à 20:07, Pierre Martel <petem001@gmail.com> a écrit :

I am building myself a few voter board and I have no clue how to program the pic in it.

Anyone have done it and could point me in the right direction?

I have some arduino uno here and some nano's

RPI as well, so if they can be used to program the chip I should be ok to do.

_______________________________________________ App_rpt-users mailing list App_rpt-users@lists.allstarlink.org http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.