I've got a good one. I'm sure someone else must have had the same issue. I've got cables from Lox cables so I'm pretty sure the cables are correct. I've programmed the radio and pull the COR down *low* on both COR AND PL. This is on a GM300 radio. I have CTCSS in the beagle.conf turned to NO, and I have HWINVERT set for the COR, the duplex is set to 0 as this is a simplex setup. But what is happening is that immediately when the beagle sees the COR it switches to transmit. As a result I can't get beagle tune rxdisplay to do anything. Anyone seen this? I'm about to go get the latest SVN (just did this a week or so ago) and rebuild. but it's very strange. I've watched the COR and it goes low and stays there when a signal is generated to the radio, so it's not cycling at the radio, it's something to do with either the Lox or the beagle software. Let me know if you would please. Alan