Scott, I have a TKR-820 using a RA-35... The info and symptoms your provided are kinda vague, please expand: - what is NOT happening that should be or - what is happening that should not be AND - what connections from the URI are going where to the repeater? AND - What are your settings for simpleUSB.conf? ~Benjamin, KB9LFZ On Fri, 2017-05-19 at 18:02 +0000, Scott Westerman wrote:

My setup is a Raspberry Pi 3, URIx (no eprom) and a Kenwood TK-820. I'm getting good audio out when I use iaxrpt, the IDs and times transmit fine, but inbound rf signals to the repeater can't be heard and don't trigger beeps, etc. When manually open the COS, I can hear the squelch noise and the inbound audio. Here are my settings.

Any advice on what I might be doing wrong?

Card is: 0 Name is: usb Rx Level: 500 Rx no-delay: 0 Rx audio-delay: 0 Tx A Level: 500 Tx B Level: 500 preemphasis: no deemphasis: no plfilter: yes rxboost: yes

PTT: Active LOW PTT status: Un-Keyed

CTCSS (input): CM108/CM119 Active LOW COS (input): CM108/CM119 Active HIGH COS (test): Un-Keyed COS (composite): Un-Keyed

Thanks very much for any wisdom you can share!

Scott W. - W9WSW _______________________________________________ App_rpt-users mailing list App_rpt-users@lists.allstarlink.org http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.