All, I'm revisiting this in case anyone else runs into the trouble. (Thanks to Mike for earlier troubleshooting help.) The final result was a couple settings in rpt.conf ended up needing to be tweaked: duplex=0 linktolink=yes This resulted in the behavior I was looking for. Now, if I could figure out why the transmit audio is so low... 73, Rachel AD9O On Sat, Jan 5, 2019, at 15:30, Rachel Olivero wrote:

On Sat, Sep 1, 2018, at 20:12, Rachel Olivero wrote:

...

Good evening all:

I presently have my TM-D700 connected to a Raspberry Pi with a URI and configured as a remote base. I'm using iaxRpt to control/use it.

I'm noticing that if there is received audio and I transmit, everything works fine. When I unkey, I get the repeater audio immediately back over iaxRpt. However, if I transmit to a repeater that has had no carrier previously, I don't hear any returned audio. I've stood next to the radio and verified that I am keying the repeater. Tonight, a station responded and I got no audio until the carrier dropped and a new signal was detected. I'm not sure if this is a D700 issue, a URI issue, or an app_rpt issue. I'm open to any suggestions.

One other question, I defined an archivedir in rpt.conf, but I don't see audio files in the directory. I see the promised text file, but no audio. Did I miss a step?

Thanks, Rachel AD9O