Mike, the correct dial is *6 6001 from the radio.To mesh node. *6 5xxx to a extension on the local box according to your files set-up. The first thing I see in you notes is that when dialing the 6001 extension, If I understand your set-up is a external mesh node so you must make the path to it in your dial string. exten=_6XXX,1,Dial,IAX2/PBX/${EXTEN} ;dial on pbx3 says if the 4 digit string starting with a 6 then dial a 6xxx extension using iax2 with the PBX trunk. PBX in my string is the name of the trunk through which my external calls starting with a 6 go through and must be stated. If not on this box, you need to tell it how to get there. Now at the node that 6xxx extension is at, there must be a iax extension that will answer a matching 6xxx call dialed. Get this to work at the local box first (5xxx) before you attempt to dial to a mesh node extension. I guess I should ask... what is on the other side of the mesh connection, a node or just an extension? ...mike/kb8jnm

-------- Original Message -------- Subject: [App_rpt-users] what am I missing ? From: Mike Lussier <mike.lussier@gmail.com> Date: Sun, January 11, 2015 10:53 am To: ALL STAR <app_rpt-users@ohnosec.org>

I stepped away from this last night. I was getting frustrated.

What I'm trying to do. dial via DTMF from radio and route the call to the local PBX in my home. I already have a Trunk established between the PBX and the BBB Node. I can place calls directly to the node, TX & RX.

When I initiate a call to the phone from my HT the only response I get back is a courtesy tone.

I have tried all of these combinations.

*6 6001 # *6 6001 6 6001 # 6 6001

There is an IAX2 trunk from the PBX to the BBB AllStar node running 1.2.1.

I can place a call to the node from the phone. I can transmit & receive.

on the BBB node :

I setup my test phone extension 6001 in iax.cnf file on the node the dial command is different dial=iax/6001

[6001] deny=0.0.0.0/0.0.0.0 username=6001 secret=xxxx dtmfmode=rfc2833 canreinvite=no context=radio-control host=dynamic trustrpid=yes sendrpid=no type=peer nat=no port=5060 qualify=yes qualifyfreq=60 transport=udp encryption=no callgroup=RPT pickupgroup=ALL dial=IAX6001 permit=0.0.0.0/0.0.0.0 allow=ulaw,gsm,h263

=======

rpt.conf

6=autopatchup,noct=1,farenddisconnect=1,dialtime= 40000 ; Autopatch up

======= In extensions.conf the phone patch is the [RADIO] context

[radio] exten => _5XXX,1,Dial(iax/${EXTEN},17); ; home phones exten => _6XXX,1,Dial(iax/${EXTEN},17); ; mesh phones<hr>_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.