My experience has sown that when this happens, you must be setting a static ip during load. the way out is to go to a command prompt at boot, enter setup by command "setup" set your ip back to dhcp (and router set-up) and check the dns also. save and exit and it should proceed if the network is working. Or you could edit the network files manually. I found for setting up a new node, it is beneficial to use dhcp and change it to static after it has finished. ...mike/kb8jnm

I am setting up a new install. I fat fingered something setting up my static IP. Now I get an error message saying I am unable to download post install script phase1.sh

Everything stops and no command prompt and I can't seem to figure out how to get back in to edit eth0. _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.