I was over today doing some more work at the site, everything is still online and operating.

I swapped the LMR400 coax out for 1/2" heliax and grounded it for one of the business band repeaters today, and remounted the GPS antenna on a better mount.
I pulled 9 runs of CAT-5 for the data radios and installed a UPS from home too.

Granted this doesn't seam like much, but there is quite a bit that goes into putting in coax.

The heliax needs connectors on it which takes about 20 min per connector to install.
Coax needs to be grounded with a ground kit after it's installed, and this requires antioxidant compound and cleaning. Then you have to seal up the jacket of the coax.
once inside the shelter you need to install a lightning arrestor with more antioxidant
then a jumper of coax is made up and fished in the ladder racks to the repeater.

Tomorrow we will get the grounding done up at the top roof and some final tweaking of the antennas completed. If all goes well I'd like to get the 440 and 900 mhz repeaters interfaced to the computer controller and off the internal controllers. This will allow us to link them to the 220 and other repeaters once the internet is hooked up.

We may be adding a pre-amp to the 440 repeater to see if we can get it hearing a bit better. The 220 is working well enough to not mess with at this point. 900 seams to actually be working well as far as I can tell. We've not heard many people on 900 to test with.

This is the 220/900/440 repeaters in the rack

This is the coax entrance in the shelter with the polyphaser lightning protectors installed

73's

-- 
Bryan Fields, W9CR
Florida Simulcast Group, Inc.