[Allstar Digital] DMRGateway

[Steve Zingman]

Is AMBEserverGPIO running? Have you tested it for proper operation?
is DMRGateway running? Are the settings in DMRGateway.ini correct?




On 01/28/2016 10:16 PM, Robert Newberry wrote:
> So I followed instructions from previous emails.
>
> I first went to my rpt.conf and did this
>
> rxchannel = usrp/127.0.0.1:34001:32001
>
> Then
>
> Configure dmrlink.cfg in /opt/dmrlink/ambe_audio as a master
>     Configure the repeater to point at the Pi as a peer.
>         cd /opt/dmrlink/ambe_audio
>         Test it by running python dmrlink.py in ambe_audio Watch the log
>     stop dmrlink.py
>     If you have rebooted DMRGateway should be running.
>         Check it with ps ax | grep DMRGateway
>             If not start it with /usr/local/bin/DMRGateway &
>         Make sure asterisk is running and connect a node to it so you 
> can hear it.
>     start python ambe_audio.py
>
> Everything looks OK on the output, other than not hearing myself. I am 
> also using TS2 TG2 which by the looks of the default ambe_audio.cfg in 
> /opt/dmrlink/ambe_audio has TG2 in the filter.
>
> Is there any other ports I need to set? It looks like most things are 
> set default.
>
>
>
> _______________________________________________
> Allstar-Digital mailing list
> Allstar-Digital at lists.keekles.org
> http://lists.keekles.org/cgi-bin/mailman/listinfo/allstar-digital

-- 
"Anything is possible if you don't know what you are talking about."
1st Law of Logic

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.allstarlink.org/pipermail/allstar-digital/attachments/20160129/3b1ab060/attachment.html>