[App_rpt] Simplex node with just RXAud/TXAud/PTT ?

[Steven Palm]

Is there any way (for testing right now, maybe short term usage for  
one node) to utilize just an HT for the simplex node?  I see that if I  
am not coming off the discriminator (I wouldn't be, I'd be using  
speaker) I can't use the DSP functions for tone decode.  For this type  
of connection I would probably have the radio set up in a squelched  
state and with CTCSS encode/decode turned on in the radio, so I'd need  
app_rpt to just detect an audio level instead of COR.

I have a connection set up that way, and the TX is fine, and for RX  
the DTMF tones do produce output on the console showing they are  
decoded, but I cannot trigger any functions while doing this,  
presumably because it either thinks no carrier is there or it thinks  
it hasn't dropped, I'm not sure which.

Any thoughts on this?  It would sure make my life easier in the short  
term.

I tried carrierfrom=dsp and carrierfrom=vox...  even carrierfrom=no  
doesn't make it response to DTMF tones.  rxsquelch shows Current  
Signal Strength of 999.

Also, if I have no unsquelched audio, the radio tune rxnoise will  
fail.  But yet for the way I would like to run it there would be no rx  
audio without a carrier present.

I know I read that a minimum connection was just rxaudio, txaudio and  
PTT so I'm hoping there is some way to make this work with the  
modified USB FOB.


Thanks,

Steve