[App_rpt-users] Two Radios, one URI...

[Peter Elke]

Thanks Steve

I guess I had stereo on the brain.  That would be a show stopper. I should have looked at the URI pins before going on and on.  

Sorry for the extra noise. 

73's
Pete

Sent from my iPhone

On Nov 25, 2010, at 9:01 AM, "Stephen Rodgers" <sales at qrvc.com> wrote:

> On 11/25/2010 07:29 AM, Peter Elke wrote:
>> Hi All,
>> 
>> 
>> 
>> After surveying all of the repeater sites, two of them are not good
>> locations for direct internet access.  The WISP is too slow or has way
>> too much jitter.
>> 
>> 
>> 
>> As a plan B will be attempting a 420mhz full duplex backhaul link to an
>> IP connected node.
>> 
>> 
>> 
>> On those "bad" sites we will be using app_rpt in a standalone mode as a
>> local repeater controller.  
>> 
>> 
>> 
>> Here is my cost saving question...  Using one URI is there a way to use
>> the right channel for node A (main repeater) and the left channel for
>> node B (backhaul 420 link)?   I can use a parallel port as needed for
>> I/O if that is an issue...
>> 
>> 
>> 
>> Pete
>> 
>> 
>> 
>> 
>> 
>> _______________________________________________
>> App_rpt-users mailing list
>> App_rpt-users at qrvc.com
>> http://qrvc.com/mailman/listinfo/app_rpt-users
> 
> That would have been a good idea except for one thing: There's only one microphone channel input on the CM108 chip, so
> it's not possible to run two radios from one URI.
> 
> Steve
> WA6ZFT
> 
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at qrvc.com
> http://qrvc.com/mailman/listinfo/app_rpt-users