[App_rpt-users] Allstar RTCM (Radio Thin Client Module) is nowavailable

Wed Dec 21 21:46:07 UTC 2011

An interesting side note form yesterday's install: While no port forwarding is necessary at the receiver sites, it is necessary at the master site. You must port forward port 667 UDP to the asterisk/app_rpt/voter. Unfortunately our IT guys were not around to set up the port forwarding for us. So we decided to use another port that was still forwarded but no longer used. Thanks to Jim having the foresight to allow any port to be used!!!

It may be of some interest to note that the port we used was one of the IRLP ports. :-)
--
Tim
:wq

On Dec 21, 2011, at 12:52 PM, Jim Duuuude wrote:

> Yeah you got it. 
> 
> Another thing I probably should have mentioned is that the RTCM/Voter module uses an
> Internet protocol that is specifically designed to work on ANY Internet connection from which
> "generic web surfing" is possible (behind any number of NAT routers/firewalls, etc and
> where LAN address is provided via DHCP). No "port forwarding" or "network provisioning"
> nightmares are necessary. You can just plug it in and it works.
> 
> JIM WB6NIL
> 
> From: ke6pcv at cal-net.org
> To: telesistant at hotmail.com; app_rpt-users at ohnosec.org
> Subject: RE: [App_rpt-users] Allstar RTCM (Radio Thin Client Module) is nowavailable
> Date: Wed, 21 Dec 2011 12:23:28 -0800
> 
> Jim,
>  
> Okay so one server running Allstar node software at a central location (like my house) can support a dozen RTCM's being used as "Generic" conventional
> full duplex (repeaters) radio interfaces on far away hilltops even if I do not want to use the RTCM GPS-Timing Multi receiver voting or Simulcast Transmitter features?
> As long as I have some sort of internet connection at the remote sites back to my house?
>  
> If I understand this correctly this would mean that:
>  
> 1) No cost of computer at the radio site.
> 2) No worry about the node computer locking up at the remote radio site and having to reboot or reset it.
> 3) No cost other than the RTCM (Radio Thin Client Module) to setup an Allstar node at the remote radio site. (no computer, no URI,  no Sound FOB) 
> 4) If I use the RTCM (Radio Thin Client Module) I have the ability to setup a normal Allstar node at the present time and then later if I want to I can upgrade the hilltop 
> for GPS-Timing Multi receiver voting and Simulcast Transmitter by simply adding a GPS receiver at the site and reconfiguring the software.
>  
> If so, this seems like a pretty cool little piece of hardware! 
>  
> Marshall - ke6pcv    
>  
>  
>   
> 
> From: Jim Duuuude [mailto:telesistant at hotmail.com] 
> Sent: Wednesday, December 21, 2011 11:52 AM
> To: Marshall Oldham; app_rpt mailing list
> Subject: RE: [App_rpt-users] Allstar RTCM (Radio Thin Client Module) is nowavailable
> 
> Yeah, that's the general idea. The location of the Linux server running app_rpt/Asterisk can be
> more or less anywhere within Internet connectivity of all of the receiver and/or transmitter sites.
> Of course, "Internet" can mean either some sort of public Internet connection, or a privately-provided
> Internet connection (low-cost microwave link(s), etc).
> 
> The only limitation is that an RTCM/Voter module *must* be located on the same LAN as the Linux
> server, to at least provide a GPS-based timing reference. A system could be set up with a server
> located in some sort of datacenter "on the ground", and all the radios could have an RTCM "on the
> hill" with them, and as long as there is Internet connectivity of some sort between each of them
> and the server, the system will work nicely. That is providing that there is an RTCM located at
> the server location also (whether or not that particular RTCM has radio hardware connected to it
> or not).
> 
> One minimal Linux server can easily support 1 or 2 dozen RTCM's (on 1 or 2 allstar nodes),
> and a larger server could easily support MANY dozens of them on dozens of allstar nodes.
> Of course, you REALLY dont want to put too many of them on a single server, being a potential
> single point of failure. For pretty much any practical purpose, the reasonable limitation is
> the point of failure/redundancy issue, not technical limitations.
> 
> I'm not sure if you were clear on this, so I thought I would mention that the RTCM is not just
> usable as a GPS-timing-based Multi-Receiver Voting system and/or a Simulcast Transmitter system.
> It can also be used as a "generic" radio interface for a conventional (non-GPS-based) either simplex
> or full duplex (repeater) radio. The advantage of doing this would be to not have the Linux
> host "on the hill" with the radio (as mentioned above). In addition, the RTCM allows for 
> portable/mobile operation with a mobile/portable Internet connection in both the GPS-based
> and non-GPS-based environments. 
> 
> JIM WB6NIL
> 
> 
> From: ke6pcv at cal-net.org
> To: app_rpt-users at ohnosec.org
> Date: Wed, 21 Dec 2011 10:54:18 -0800
> Subject: Re: [App_rpt-users] Allstar RTCM (Radio Thin Client Module) is nowavailable
> 
> I have been looking at the Allstar RTCM (Radio Thin Client Module) and it really looks like a GREAT product and addition to the already cool Allstar hardware.
>  
> Among all the other cool features of the RTCM (Radio Thin Client Module) like Transmitter Simulcasting and Receiver Voting, if I understand the documentation
> correctly you can use this very small Radio Thin Client Module at a remote radio site to set up an Allstar repeater node if the site has internet connection without a COMPUTER at the site?
>  
> Then you can point the node on the hilltop back to a server on the ground somewhere that is easy to get too? 
>  
> How many total sites can you use Radio Thin Client Modules on and point back to a single server on the ground?  
>  
> If this is the case, All I can say is WOW, how cool!
>  
> 73
>  
> Marshall
>  
>  
>  
> 
> From: app_rpt-users-bounces at ohnosec.org [mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Mark Guibord
> Sent: Sunday, December 18, 2011 11:03 AM
> To: app_rpt-users at ohnosec.org
> Subject: [App_rpt-users] Allstar RTCM (Radio Thin Client Module) is nowavailable
> 
> Allstar RTCM Radio Thin-Client Module, an Open-Source VOIP-Based Voting Multi-Receiver and Simulcast Transmit System is now available for purchase. 
>  
> For more information visit http://micro-node.com/thin-m1.html 
>  
> Regards,
> Mark Guibord
> Micro-Node International
>  
>  
> 
> _______________________________________________ App_rpt-users mailing list App_rpt-users at ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20111221/90bdb1aa/attachment.html>