[App_rpt-users] Transmit tuning with susb tune?

[Tim Sawyer]

Use *989 (cop,4) to generate a 1Khz tone at 3Khz dev. Use *989 to toggle it off again.
--
Tim
:wq

On Mar 5, 2011, at 6:20 PM, Phil N6TCT wrote:

> Thanks, Jim.  But no, "susb tuna txa" (or txb) does not generate tone
> -- that was my question: what should I use to generate tone to get
> things calibrated?
> 
> Thanks!
> 
> Phi, N6TCT
> 
> On Sat, Mar 5, 2011 at 5:30 PM, Jim Duuuude <telesistant at hotmail.com> wrote:
>> susb tune txa (or txb).. i dont remember whether it generates tone
>> susb tune rx for rx
>> and dont forget about susb tune rxdisplay
>> 
>> 
>> 
>>> Date: Sat, 5 Mar 2011 17:13:53 -0800
>>> From: phil.n6tct at gmail.com
>>> To: app_rpt-users at ohnosec.org
>>> Subject: [App_rpt-users] Transmit tuning with susb tune?
>>> 
>>> Ok, so much progress has been made now that Jim has me using "susb"
>>> instead of "radio" commands when using the simpleusb channel. :-) I
>>> really like "susb tune rxdisplay" for receive audio level tuning.
>>> 
>>> But: what is the recommend equivalent to"radio tune txvoice <xxx>"
>>> command, the one that would generate a 1 kHz tone at a what should be
>>> 3 kHz deviation so that I could use a service monitor to adjust the
>>> txgain appropriately? susb tune txa and txb just set the levels,
>>> they don't actually transmit.
>>> 
>>> Thanks!
>>> 
>>> Phil, N6TCT
>>> _______________________________________________
>>> App_rpt-users mailing list
>>> App_rpt-users at ohnosec.org
>>> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>> 
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users