[App_rpt-users] for those Limey Linux and or D525MW users who are brave enough

[Jon Rorke]

Hi Jim, does this new Limey distro support chan_usbradio full dsp,  full 
duplex and can it support multi nodes?

Thanks

Jon VA3RQ

On 10/6/2011 9:46 AM, Jim Duuuude wrote:
> I have compiled a test version of Limey Linux version 1.1.5 that appears
> to properly support the new Intel D525MW Atom motherboard.
>
> This is an 'augmented' version of the i686-suported-1.1.5 release, so
> it *should* work on all the previously-supported i686 processors, also.
>
> There were some rather major changes (necessary to support SATA
> interfaces) in the hard disk driver stuff (even for those MB's that only
> have IDE), so it would be nice if some people could verify that this still
> works on non-D525MW motherboards (at least the ones that work in
> the normal release).
>
> I have tested this release on both a D525MW and the D945GCLF series
> motherboards, and it seems to work just fine.
>
> Also, if you have 5 minutes to wait for it to boot (since the SWINE 
> boot loader does
> not support anything faster then USB 1.1 speed, YUCH!), you can flash
> the distro onto a USB pen drive (>= 128 MB), and it will work. Once the
> OS loads, it runs at full speed, just the initial boot load is 
> PAINFULLY slow.
>
> If you dare, here is the URL for this version:
>
>
> http://stats.allstarlink.org/limeylinux/downloads/cfimg-D525MW-1.1.5.tar.gz
>
> JIM WB6NIL
>
>
>
>
>
>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20111006/06feecad/attachment.html>