[App_rpt-users] Set up URI rxnoise

[Jim Duuuude]

4v pk-pk... unless you have "rxboost" set to "no" youre probably blowing its
little brains out with so much signal.

Jim WB6NIL

From: eric at efratnetworks.com
To: app_rpt-users at ohnosec.org
Date: Sun, 15 Apr 2012 16:50:27 -0400
Subject: [App_rpt-users] Set up URI rxnoise



Folks,  I am Eric, 4Z5UG.  I am setting up my first Allstar node using an URI to my Santec FM-240 2 meter transceiver.  I am picking off discriminator audio from the radios receiver.  I have 4 volts PtoP of noise with no carrier present.  When I run the RXnoise test, it says that the "target is 27000", "tolerance 2750".  My test measurement is 23000.   I would think that 4 Volts p-p would be enough to get it right.  Is there a way to change the target to put it in range of my noise output?  73,   Eric, 4Z5UG    
_______________________________________________
App_rpt-users mailing list
App_rpt-users at ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20120415/39422b63/attachment.html>