[App_rpt-users] no PTT when simplusb selected.

[Tim Sawyer]

Take out one of the usb stanzas in simpleusb.conf and then check your rpt.conf for a matching rxchannel

ie, either

rxchannel = SimpleUSB/usb 

or 

rxchannel = SimpleUSB/usb28522 

depending which you leave in simpleusb.conf

--
Tim
:wq

On May 3, 2012, at 2:43 PM, David Kierzkowski wrote:

> Also i am currently using
> 
> carrierfrom=no
> ctcssfrom=no
> for the below config was jsut from trying to find a working combination
> when posted the first msg..
> 
> 
> On 5/3/2012 5:33 PM, David Kierzkowski wrote:
>> I have a ACID install with URIx connected to a icom v8000. Want to setup
>> as a simple repeater. Through the portal when setting the interface to
>> simpleusb, no PTT will work, but i can hear recieved audio.
>> if i setup the interface as usbradio (i dont want / radio is doing
>> ctcss/ speak level audio ) then the radio will PTT and pass
>> overmodulated audio (as expected) but no RX audio will pass.
>> 
>> i have a feeling theres a config issue with simpleusb.conf.. do u guys
>> see anything? I dont know why it creates the [usb] device stanza. Also
>> while in the simple_tune_usb.sh i can see and set the RX levels properly
>> and manually flash the PTT.
>> 
>> [general]
>> 
>> [usb]
>> 
>> hdwtype=0
>> rxboost=1
>> txboost=1
>> carrierfrom=dsp
>> ctcssfrom=dsp
>> txmixa=composite
>> txmixb=0
>> invertptt=0
>> duplex=1
>> rxondelay=0
>> eeprom=0
>> 
>> [usb28522]
>> 
>> hdwtype=0
>> rxboost=0
>> txboost=1
>> carrierfrom=usb
>> ctcssfrom=usb
>> txmixa=voice
>> txmixb=no
>> invertptt=0
>> duplex=0
>> rxondelay=1
>> eeprom=0
>> 
>> 
>> and here is simpleusb_tune_usb28522.conf
>> [usb28522]
>> ; name=usb28522
>> ; devicenum=2
>> devstr=4-4
>> rxmixerset=400
>> txmixaset=500
>> txmixbset=500
> 
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users