[App_rpt-users] TX Tone Drop out Time

[Corey Dean]

Here is the cop commands you may want to look at as well.  59 will always transmit, 58 will only transmit when there is an active signal.

 *  58 - Tx CTCSS On Input only Enable
 *  59 - Tx CTCSS On Input only Disable


Corey N3FE
________________________________________
From: app_rpt-users-bounces at ohnosec.org [app_rpt-users-bounces at ohnosec.org] On Behalf Of Ken [ke2n at cs.com]
Sent: Sunday, September 16, 2012 7:54 AM
To: 'Jim W7RY'; app_rpt-users at ohnosec.org
Subject: Re: [App_rpt-users] TX Tone Drop out Time

This is in usbradio.conf

txtoctype=notone     ; Transmit tone control type: no,phase,notone
                     ; no - CTCSS tone encoding with no hang time
                     ; phase - encode CTCSS and reverse phase
                     ; AKA ("reverse burst") before unkeying TX
                     ; notone - encode CTCSS and stop sending tone before unkeying TX
                     ; AKA ("chicken burst")


If you select notone (as shown here), then the PL drops about 600 ms before the carrier drops.
Most people like it that way ;-)

Ken


From: app_rpt-users-bounces at ohnosec.org [mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Jim W7RY
Sent: Sunday, September 16, 2012 12:05 AM
To: app_rpt-users at ohnosec.org
Subject: [App_rpt-users] TX Tone Drop out Time

I had my PL tone encoder (node generated) drop out before the carrier dropped out. It seems to have quit working. The PL generator is working fine, but the timing seems to changed.  I don’t seem to find the command now. I'm probably not be looking in the right file.

Can someone please tell me where that setting is?

Thanks!
73
Jim W7RY


--
This message was scanned and is believed to be clean.
Click here to report this message as spam.<http://simba.repeater.net:8080/cgi-bin/learn-msg.cgi?id=5525E222A.A9956>