[App_rpt-users] RTCM use in Off-line/fail-over mode

[Tim Sawyer]

RTCM duplex mode 3 support provides mobile full duplex as the repeat audio loops through the RTCM. It’s 100% analog with no delay what so ever. Get RTCM firmware 1.31 and look at menu item 18. Remember the set duplex=3 in your rpt.conf
--
Tim
:wq

On Dec 22, 2013, at 4:16 PM, Mike/W5JR <w5jr.lists at att.net> wrote:

> I think you will have to "front end" it with an inexpensive 2 port controller such as an NHRC-4 (available in kit form), an RC-100 or Linker II. Then you set the RTCM (and node) for simplex or duplex non-repeat. This is what I'm implementing right now with the NHRC. 
> 
> Gotta have duplex mobile!!!
> 
> tnx
> Mike / W5JR
> Milton GA
> 
>> On Dec 22, 2013, at 5:01 PM, "41.2 Jim" <41.2jim at gmail.com> wrote:
>> 
>>        I understand that when the RTCM goes into fail-over / off-line mode and it becomes a simple repeater, and that all the local repeater audio delay goes away(confirmed), Is their a way to use the RTCM  in this mode and not be "off-line" ? So we have the system behave normally (not off-line) but  with no local repeater audio delay?(easier to duplex with no delay) 
>> 
>> I have been looking through the archives to find the thread as I was advised that this modification can / has been be done and it's in  the archives somewhere, I just cant find it
>> Or have I been miss informed?
>> 
>>   Jim Frederick KF6QBW
>> 446.600-  100.0 PL Repeater
>>     AllStar Node # 28839
>>         Skype = jim41.2
>> _______________________________________________
>> App_rpt-users mailing list
>> App_rpt-users at ohnosec.org
>> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users