[App_rpt-users] Squlech Tail

[Jon Rorke]

Use radio tune rxsquelch to set the squelch.

In ACID:

AST_2249_XCN*CLI> radio tune rxsquelch
Current Signal Strength is 741
Current Squelch setting is 501

If the setting is lower then you will hear squelch crash.

Set the squelch above the measured level:

AST_2249_XCN*CLI> radio tune rxsquelch 800
Changed Squelch setting to 800

AST_2249_XCN*CLI> radio tune rxsquelch
Current Signal Strength is 749
Current Squelch setting is 800
AST_2249_XCN*CLI>

Then do a "radio tune save" to save the setting.

The squelch should now close very fast like the Micor squelch.

It works very well.

Jon VA3RQ



On 7/23/2013 12:43 PM, Tim Sawyer wrote:
> There is for TX (mobile RX) if using the RTCM for your radio 
> interface. In that case the setting is in the RTCM.
>
> If other interfaces support STE I am not aware of it.
> --
> Tim
> :wq
>
> On Jul 23, 2013, at 8:58 AM, Johnny Keeker <cypresstower at yahoo.com 
> <mailto:cypresstower at yahoo.com>> wrote:
>
>> Is there a squelch tail eliminator setting for ACID in the full 
>> duplex mode?
>> _______________________________________________
>> App_rpt-users mailing list
>> App_rpt-users at ohnosec.org <mailto:App_rpt-users at ohnosec.org>
>> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>
>
>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20130723/51170be2/attachment.html>