[App_rpt-users] Remote base Memories

[Mark Johnston]

Hello everyone,

I have finally got the ic-706 remote base partially working
I can scan freq, move up in freq, and read status, Now that the commands
also the init=freq..... works when I connect so it can set the frequency.
just fine, yet if I do *1444*000*0... etc does not work
If I do *0001 for memory 001 etc, I get 'memory not found'

which the memory is in the rpt.conf

[memory]
  ;Syntax : CC=RRR.RRR,PPP.P,AAAAA
  ;          C=Channel Number
  ;          R=RX Frequency
  ;          P=PL Frequency
  ;          A=Attributes
  ;
  ;Attributes : a=AM   b=LSB  f=FM  u=USB
  ;             l=Low Power   m=Medium Power   h=High Power
  ;             -=Minus TX Offset    s=Simplex     +=Plus TX Offset
  ;             t=TX PL on    r=RX PL on
  ;
004=147.700,123.0,fshrt
005=147.100,123.0,fshtt
006=003.860,100.0,bshrt
init=003.980,100.0,bshrt ;Set to this on startup


This is just above the macro section below the functions-remote...

At the end of the file I tried[memory]

[memory]
001=147.700,123.0,fshrt
002=147.100,123.0,fshtt
003=003.860,100.0,bshrt


None of these work, always says 'memory not found'

Any ideas? I know I am getting close to making this work!

0=remote,1                             ; Retrieve Memory
1=remote,2

Mark KC7DMF
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20130920/309c5158/attachment.html>