[App_rpt-users] I/O using parallel port

[Jamey Wright]

Nope.  

 

If I set pp2 = out0  I read about 100 ohms

If I set pp2 = out1 it reads open

 

Entering *8411 or *8401 yields no change.  (from rpt.conf  8401=cop,61,pp2=0
8411=cop,61,pp2=1)

 

The node plays back 2 beeps

Watching the CLI I see  --Hungup 'Zap/pseudo-123418903'  (number changes
each time)

 

Commands are being sent from IAXRPT and from a locally connected radio

 

 

Jamey

WR4JW

 

 

From: Harold (K7ILO) [mailto:k7ilo1 at gmail.com] 
Sent: Saturday, August 08, 2015 1:34 AM
To: 'Jamey Wright' <jamey.wright at charter.net>
Subject: RE: [App_rpt-users] I/O using parallel port

 

Follow this Jamey...  http://www.qsl.net/k0kn/irlptoallstar.html

Your info should be in either usbradio.conf or simpleusb.conf

Just read through it and you'll get it.

I use this method also.

 

Harold

K7ILO

 

From:  <mailto:app_rpt-users-bounces at ohnosec.org>
app_rpt-users-bounces at ohnosec.org [
<mailto:app_rpt-users-bounces at ohnosec.org>
mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Jamey Wright
Sent: Friday, August 7, 2015 4:29 PM
To:  <mailto:app_rpt-users at ohnosec.org> app_rpt-users at ohnosec.org
Subject: [App_rpt-users] I/O using parallel port

 

Since I have the node computer here at house for a day or 2 instead of at
the tower site I decided I would go ahead and configure the I/O for
something I have in mind in the future.  I seem to be having some issues
though.  When I enter *8401 from IAXRPT, I get back "beep beep"  but I don't
see a state change with my DMM across pin 2 and ground

 

 

In BIOS, the parallel port is configured at address 378 and IRQ7 and in EPP
mode.

 

I have this in the RPT.CONF:

 

[functions27981]

 

<clipped for brevity>

 

80=status,1

81=status,2

 

8401 = cop,61,pp2=0

8402 = cop,61,pp3=0

 

8411 = cop,61,pp2=1

8412 = cop,61,pp3=1

 

901=cop,33                         ; Local telemetry output enabled

902=cop,34                         ; Local telemetry output disabled

903=cop,35

 

And I have this in SIMPLEUSB.CONF:

 

; SimpleUSB configuration

;

[general]

 

pp2=out1

pp3=out0

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20150808/5451a1d8/attachment.html>