[App_rpt-users] Sending DTMF to remote device

[mike at midnighteng.com]

Without knowing all the exact particulars that would be important for
giving help on this, I can only suggest,
setting-up a new node at remote server just for your other controller.

The set-up for that is quite a bit different from normal.
You have to change the duplex mode and add linktolink=yes in rpt.conf so
there is no repeater tail etc.

Or, depending on your exact set-up, you might be able to use regenerate
dtmf on output from macros if there are a limited number of command
strings you use.

just some ideas,

...mike/kb8jnm



> I am trying to send DTMF codes to an SCOM controller via an AllStar link.
> I have enabled propagate_dtmf=yes on both sides, and I think the tones are
> reaching the remote node, but it is not been sent out on the remote end.
> I have seen references suggesting you this in command mode, but I want the
> remote node to ignore the tones, and output it to the SCOM instead, so
> this doesn't seem appropriate.  Does anybody have a HOWTO on this?
> 73 Willem AC0KQ
>
> ================================================================
> Dr. Willem A. Schreuder,  President,  Principia Mathematica
> Address:  445 Union Blvd, Suite 230,  Lakewood, CO  80228, USA
> Tel: (303) 716-3573   Fax: (303) 716-3575
> WWW: www.prinmath.com   Email: Willem.Schreuder at prinmath.com
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>
> To unsubscribe from this list please visit
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down
> to the bottom of the page. Enter your email address and press the
> "Unsubscribe or edit options button"
> You do not need a password to unsubscribe, you can do it via email
> confirmation. If you have trouble unsubscribing, please send a message to
> the list detailing the problem.
>