[App_rpt-users] Problem with a post-install on an inactive node(28781)

[kk6ecm]

My experience says asterisk is not happy. Assuming you have gone though the
tune process for your URI, it could mean that devstr=a-b in
usbradio_tune_xxx does not match the USB address as seen in lsusb, e.g. 

Bus 00a Device 00b: ID 0d8c:013a C-Media Electronics, Inc.

If that is OK, then I'd check for a typo in one of the asterisk .conf files.

Bob
kk6ecm

-----Original Message-----
From: app_rpt-users-bounces at ohnosec.org
[mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Dave Newmyer
Sent: Monday, September 07, 2015 7:09 PM
To: app_rpt-users at ohnosec.org
Subject: [App_rpt-users] Problem with a post-install on an inactive
node(28781)

Hello,

I have been attempting to get my simplex node back up and running after 
being off of the air for a couple of years.  The ULI device and radio 
are the same, but the computer, installation software, ect. are all 
different. I am using a new install from an acid-centos.iso I downloaded 
a couple of days ago.

At post-install,  I get the following:
mpg123:no process killed.
Asterisk ended with exit status 1
Asterisk died with code 1
Automatically restarting Asterisk

This repeats over and over.  I checked the archives, and found a series 
of postings from someone who had a similar problem some time back.
In reading the log file  /var/log/asterisk/messages  the errors refer to 
a problem with Zaptel.

One of the suggestions was to update Asterisk from SVN, then update Zaptel.

After doing this, Asterisk started, and I was able to perform system 
info and time DTMF commands to my node.

Later, I tried resetting the computer and after restarting it, I am back 
to the
mpg123:no process killed.
Asterisk ended with exit status 1
Asterisk died with code  1
Automatically restarting Asterisk

Errors over and over and over again.

I am thinking that possibly my config files on the AllStar.org website 
might have an issue, but on one of my re-installs of the software from 
the cd, I chose not to download the remote configs.

Anyway, I am not sure what to try next.

73,

Dave N
N0KM


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


_______________________________________________
App_rpt-users mailing list
App_rpt-users at ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to
the bottom of the page. Enter your email address and press the "Unsubscribe
or edit options button"
You do not need a password to unsubscribe, you can do it via email
confirmation. If you have trouble unsubscribing, please send a message to
the list detailing the problem.