[App_rpt-users] DIAL Raspberry Pi 2 Delay

[Steve Zingman]

 Matt,
The 3 is supported check the download link.

73, Steve N4IRS

Sent via smoke signal (AT&T 4G LTE)


-------- Original message --------
From: Matt Brennan <brennanma at gmail.com>
Date: 04/08/2016 3:33 PM (GMT-05:00)
To: Kevin Custer <kuggie at kuggie.com>
Cc: app_rpt-users at ohnosec.org
Subject: Re: [App_rpt-users] DIAL Raspberry Pi 2 Delay

This is a portable crossband repeater setup in a Pelican case. It is
intended to be deployed during public service events. Raspberry Pi's were
used to keep the form factor small (and the cost down, since it's all out
of pocket).

We tried to use a Raspberry Pi 3, but unfortunately it doesn't seem to be
supported yet. We aren't really doing any processing. It's two radios on
simplex channels, with a third that transmits on both. The largest number
of audio paths enabled at any given time is 2. A Raspberry Pi 2 should be
able to handle that. In fact, the CPU never goes above 30%. I have another
one running Asterisk that can handle managing 10 active SIP calls without
an issue.

-Matt


On Fri, Apr 8, 2016 at 11:16 AM, Kevin Custer <kuggie at kuggie.com> wrote:

> 3 radios on one Raspberry Pi 2?  I guess my next question would be why?
>
> If you are running SimpleUSB now, switching to USBradio will likely make
> the situation worse as there is generally more DSP going on in USBradio
> than SimpleUSB - depending on exact configuration.
>
> Raspberry Pi's are inexpensive as compared to some PC's which could have
> enough horsepower to properly operate 3 or 4 radio interfaces, even in full
> DSP.  If you really want to run multiple radio adapters on a single
> appliance, consider choosing a hardware platform powerful enough to do it
> properly.
>
> Kevin
>
>
> On 4/8/2016 9:52 AM, Matt Brennan wrote:
>
>> Sorry - 3. 3 separate simplex radios.
>>
>> Someone else individually replied to me and said it's likely an issue
>> with SimpleUSB and I should try using usbradio instead. I will be trying
>> that tomorrow, but still open to other suggestions.
>>
>> Thanks again,
>> Matt, NM1B
>>
>
>

_______________________________________________
App_rpt-users mailing list
App_rpt-users at ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down
to the bottom of the page. Enter your email address and press the
"Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email
confirmation. If you have trouble unsubscribing, please send a message to
the list detailing the problem.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20160408/62d9970f/attachment.html>