[App_rpt-users] RX Input Adjust Failed

[kk6ecm]

I discovered app_rpt does not like ctcssfrom=no. Why? (I'm using DIAL).

What am I missing?

Thanks,
Bob
kk6ecm
73

-----Original Message-----
From: kk6ecm [mailto:kk6ecm at gmail.com] 
Sent: Sunday, May 22, 2016 10:37 AM
To: 'app_rpt-users at ohnosec.org'
Subject: RX Input Adjust Failed

What could cause the Error: RX Input Adjust Failed?

DONE tries=12, setting=1000, meas=58, sqnoise=13
ERROR: RX INPUT ADJUST FAILED.

No RF input to the radio.

I'm attempting to setup a substitute receiver for testing, but am
experiencing difficulty setting it up, and not wanting to make a switch to
simpleusb, thus making the minimum number of changes.

The substitute receiver (Yaesu FT-1500M) is detecting CTCSS, with USB COR
out, and I'm using the speaker output. (see below conf file)

Any thoughts?

Thanks,
Bob
kk6ecm
73


from usbradio_tune...

hdwtype=0	
rxboost=1
txboost=1
rxctcssrelax=1
txctcssdefault=107.2
rxctcssfreqs=107.2
txctcssfreqs=107.2
;rxctcssoverride=0
;carrierfrom=dsp
carrierfrom=usb   ;dsp
ctcssfrom=no    ;usbinvert
rxdemod=speaker ;flat
txprelim=no
txlimonly=no
txtoctype=notone
txmixa=composite
txmixb=no
invertptt=0
duplex=1
rxondelay=0
rxnoisefiltype=0
eeprom=0