the COS/COR is not needed because the settings in the usbradio.conf are going to be: carrierfrom=dsp ctcssfrom=dsp The Linux box is going to use DSP to detect the the difference between the white noise and a modulated signal. Once it detects that difference, it will send the audio over the network to whatever node you are connected to. Ensure that you use the radio-tune-menu after you make the setting adjustments and reboot. The radio-tune-menu going through the steps will help you ensure that your audio into the network is set to the proper deviation, ability to detect the difference between white noise and an actual signal, and proper TX audio levels on your end. This will ensure your TX deviation is set to 3KHz with a 1KHz tone and vise-versa. It is wise to use a service monitor when using the radio-tune-menu. If you do not have access to one, become a friend with someone who does, or ask members of your radio club. I'm after two or three hours of pure, continuous looking, you will find someone who has one. The allstarlink.org website has an alternative method that uses a radio that should be known accurate. Meaning it's TX audio deviation is correct, and it's on frequency, as best as a amateur radio is going to be. If you do not have a tone generator, the open source world has plenty of programs that you can use the computer to generate a 1KHz tone. It's not complicated, and doesn't take long to setup using a service monitor. Once you go through the steps, the last step will be to save what you've done and then reboot the node. I used the above methods to setup my box, and it's works wonderful. ~Benjamin, KB9LFZ allstar 28569 On Wed, 2013-04-10 at 14:05 -0700, Mike wrote:
I have decided to build an allstar node. Got the radio, got the account, got the URI, got the Linux box, got the software, now I have to build the cable and put it all together.
But in looking at the cable description on the DMKeng site, I don't see any COS signal used.
http://www.dmkeng.com/images/9080-GM300.pdf
Isn't the COS from the radio needed to suppress transmitting dead autio over the network? I thought a COS signal was required. It's talked about as necessary but the signal isn't shown in the gm300 cable description.
Anyone care to explain why this is not needed or when it is needed? And if it is needed, which pin on the 25 connector would it go to?
Mike _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users