On some bios you csn shut acpi. Jusr check in the power settings. --- Message initial --- De : "C B" <harvard5362@yahoo.com> Envoyé : 26 août 2013 17:01 A : "pete M" <petem001@hotmail.com>, "David Osborn" <david.osborn@manx.net>, app_rpt-users@ohnosec.org Objet : Re: Re : Re: [App_rpt-users] Asterisk ended with exit status 1 Thank you Sounds like I should be ok running that way as I do not think I need any power control. Could a BIOS setting in power management somehow conflict with ACPI, perhaps a dumb question however I thought I would ask it. Chris ________________________________ From: pete M <petem001@hotmail.com> To: C B <harvard5362@yahoo.com>; David Osborn <david.osborn@manx.net>; app_rpt-users@ohnosec.org Sent: Monday, August 26, 2013 1:48 PM Subject: Re : Re: [App_rpt-users] Asterisk ended with exit status 1 acpi is power management... Without acpi you have full power all the time. No powee saving stuff. I think it is used to monitor fan speed bur not sure. --- Message initial --- De : "C B" <harvard5362@yahoo.com> Envoyé : 26 août 2013 15:04 A : "David Osborn" <david.osborn@manx.net>, app_rpt-users@ohnosec.org Objet : Re: [App_rpt-users] Asterisk ended with exit status 1 Hi I tried the following and it did stop the error massages. - Disable ACPI and reboot your system. You need to edit /boot/grub/grub.conf and modify kernel parameters as follows: kernel /vmlinuz-2.6.18-53.1.4.el5 ro root=LABEL=/ vga=0x314 acpi=off However I am not sure what ACPI does for the allstar link. will this have any negative impacts? or does this tell anyone what the problem may be? Chris ________________________________ From: David Osborn <david.osborn@manx.net> To: app_rpt-users@ohnosec.org Sent: Monday, August 26, 2013 10:10 AM Subject: [App_rpt-users] Asterisk ended with exit status 1 I claim no expert knowledge here but I was mucking around trying to get Acid running on a thin client – just for the heck of it really. Anyway, I got this error message, along with the log messages about a problem with the Zaptel Configuration, and I found a reference to this issue here: http://www.easyasterisk.org/modules/smartfaq/faq.php?faqid=1 Booting the thin client with ACPI disabled cured the problem with Zaptel, but then the LAN port wouldn’t come up L so I was still stymied! Anyway I don’t know if this will help, but it might be worth a go. David Osborn GD4HOZ _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users