Using a t5700 from HP I was able to do 2 thing, one was a homebrew dstar repeater with 2 Kenwood LMR radios, Then I did the same thing with Allstar on a MSR2000 vhf repeater, exact same harware, but the interface, one was a URI for the allstar box, the other was a dvrptr. I had to replace the 1gb flas drive (44 pin ide) inside the Thin client to a small 4 gb hard disk that look exactly like a compact flash memory card.. http://www.ebay.ca/itm/Hitachi-HMS360404D5CF00-4GB-3-6K-CF-Type-II-1-MicroDr... It was connected to a 44 pin IDE to CF adapter http://www.ebay.ca/itm/Notebook-Hot-Mini-PCI-CF-Compact-Flash-to-2-5-IDE-44-... with an ide 44 pin female female cable to the Thin Client. there are 5 and 6gb drive just like that too.. simple as pie. it had enough horse power to run dsp on ONE node. a second node would brake it. but would run 2 simple usb easy.. I have a small video showing the dstar stuff I did. http://www.youtube.com/watch?v=0Ly5xFGBFXQ From: Jonathan Weirmeir Sent: Tuesday, August 27, 2013 7:52 PM To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] System ideas for a first install A while back, I asked for tips with virtualization. However, since it's my first time, I'd like to use a dedicated box for app_rpt. I'm interested in a system solution that's fairly low profile, but most importantly, that's low in power consumption and heat generaton (which rules out the spare Pentium 4 space heater I have sitting around). I've read that some have repurposed thin clients for app_rpt, with different levels of success. Anyone have any suggestions for systems that have enough horsepower to run up to four nodes on a single box, and around say $100 or less? I'm using URIx's and USB sound fobs. Thanks, can't wait to get going with app_rpt. Jonathan -------------------------------------------------------------------------------- _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users