So, you're saying the tail is still there, but you don't hear it because Asterisk stops transmitting the CTCSS tone just before the tail starts, meaning the receiving radios actually "don't" hear it? Interesting way of looking at the issue, thats for sure...! On 18/02/2013 4:26 AM, "Ken" <ke2n@cs.com> wrote:
Ciao Thomas****
** **
The squelch “tail” is usually eliminated by using CTCSS (so called PL) on the transmitted signal and corresponding PL detection on receive. I am not sure how common that is in EU though …****
** **
On the repeater you need (usbradio.conf)****
** **
txtoctype=notone****
** **
With this, Asterisk stops transmitting the CTCSS tone about 600 milliseconds before dropping the carrier – radios that are using tone squelch will not hear any noise at all when the other station stops transmitting. ****
** **
Some receivers need > 600 milliseconds for the tone squelch action. It is possible to make this time delay longer, if needed.****
** **
73****
** **
Ken****
** **
*From:* app_rpt-users-bounces@ohnosec.org [mailto: app_rpt-users-bounces@ohnosec.org] *On Behalf Of *Thomas Delmonego *Sent:* Sunday, February 17, 2013 11:53 AM *To:* app_rpt-users@ohnosec.org *Subject:* [App_rpt-users] Avoid squelch noise after receiving a signal** **
** **
Hi, it's possible to avoid the typical squelch noise after the reception of a valid signal from a repeater RX? Is there a specific setting, if yes in what file? Many thanks for help! 73! Thomas, IW3AMQ****
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users