30 Nov
2014
30 Nov
'14
1:46 p.m.
Hello all... I have been working on an agile remote base using an Icom 706. I have seen a lot of posts and read a lot of ideas on using this radio. I first attemped using this under the Beagle Bone but I didn't have any luck. SO I switched to an ACID install that was previously working as a Repeater Node. I first added the remote stuff back to the rpt.conf - and the symptom returned. The only working config has the line 'remote = ic706' commented out. Anyone have any ideas on why the USB interface won't start, or the node would die just because the remote statement was added? I could use some pointers? -- *Samuel T. Nabkey - K8SN*