fyi, mantis case 0000019 opened. Jim On Tue, May 26, 2009 at 8:39 AM, James Nessen <nessenj@jimsoffice.org>wrote:
Just to add..
I left my node connected to the western reflector (monitor mode) all night long and fired up the HT this morning to find that the connection to was still established, however the audio was sounding like there is a codec mismatch (raspy and broken).
Any ideas?
Jim, K6JWN
On Mon, May 25, 2009 at 10:14 PM, James Nessen <nessenj@jimsoffice.org>wrote:
are there any cli commands to enable extra debugging for chan_irlp? I have recently noticed while connected to an irlp station that after x amount of time (varies), something happens that causes asterisk to crash. I normally notice this behavior while someone is talking, their voice stream will be fine, then start to chop up and then silence (crash).
So far, I have noticed this behavior on IRLP 9456 (UNCOMP). I am running Limey Linux (1.0.7?) on the i3386. I will leave it dialed up over night to an ADPCM station to see if the problem persists there as well.
Jim -- Jim Nessen K6JWN Email: nessenj@jimsoffice.org | Ph: 530.979.0894 IRLP: Nodes 3598 and 3633 | Echolink: 83598 K6JWN-R | AllStar: Nodes 2142 and 2165
-- Jim Nessen K6JWN Email: nessenj@jimsoffice.org | Ph: 530.979.0894 IRLP: Nodes 3598 and 3633 | Echolink: 83598 K6JWN-R | AllStar: Nodes 2142 and 2165
-- Jim Nessen K6JWN Email: nessenj@jimsoffice.org | Ph: 530.979.0894 IRLP: Nodes 3598 and 3633 | Echolink: 83598 K6JWN-R | AllStar: Nodes 2142 and 2165