Skyler, I think your are expecting a COR toggle from a signal COS that has not been described. You will need a definition for PL if that is where you intend to get a valid signal argument for rx in DSP. Perhaps you intend to use VOX toggle, but that needs to be described also. Hope that leads you in the right direction. ...mike/kb8jnm
I am really confused right now.
I am using a URI with some kenwood TK-941 radios for a repeater. I am using De-emphasized audio.
Here is what is happening. I am using usbradio.
I set the rxctcssoverride to 1 for testing.
I turn the squelch off in the radio, and put carrier from to DSP. (Yes, I know, this is the wrong type of audio for DSP). I go to radio tune menu, set the squelch to zero, and I hear the white noise being repeated perfectly.
Now, I set the carrier from to USB. When I turn the squelch off on the radio, the red light enables, and the transmitter transmits. However ... There is no white noise being repeated, just a plain carrier. What???
I tried this on the computer as well as the raspberry pi. My audio input is on the left channel. Even when I set the input volume to 999, I still don't hear anything, just a carrier.
So I know -Speaker Audio is coming into the computer through the URI -When DSP is enabled, and the squelch is set to zero both on the computer and the radio, audio is repeated -COR is set up because the transmitter will key up when the receiver gets a signal
So now I need to figure out what is preventing the audio from rebroadcast when the input is set to usbinvert.
73 Skyler KD0WHB _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.