Since I have the node computer here at house for a day or 2 instead of at the tower site I decided I would go ahead and configure the I/O for something I have in mind in the future. I seem to be having some issues though. When I enter *8401 from IAXRPT, I get back "beep beep" but I don't see a state change with my DMM across pin 2 and ground In BIOS, the parallel port is configured at address 378 and IRQ7 and in EPP mode. I have this in the RPT.CONF: [functions27981] <clipped for brevity> 80=status,1 81=status,2 8401 = cop,61,pp2=0 8402 = cop,61,pp3=0 8411 = cop,61,pp2=1 8412 = cop,61,pp3=1 901=cop,33 ; Local telemetry output enabled 902=cop,34 ; Local telemetry output disabled 903=cop,35 And I have this in SIMPLEUSB.CONF: ; SimpleUSB configuration ; [general] pp2=out1 pp3=out0