On 01/27/2015 08:43 AM, ea8ee wrote:
hello everyone! I tried to configure your rig kenwood V7 and uri dmk connected to our repeater that has a tail using the CTSS tail repeater is not heard using the usbradio setting using carrierfrom = dsp works but the problem that some users using the same CTSS open the rx access and another users not get to be heard through the dsp uri any option to use the rx CTSS V7 to delete tail repeater instead of dsp uri ?
I'm using a TM-V7A as well, but it's only a 2m node, and simplex as well. Connected the DMK URI to the packet port. Discriminator audio (9600 baud line) available for flat audio! Sounds awesome! As for turning off the tail on the allstar machine, look at the duplex modes... duplex= Submitted by hwstar on Sun, 05/17/2009 - 14:13 This configuration option tells app_rpt how to handle audio passed through the radio interface. Please note that it does not perform the same function as the duplex= configuration option in the configuration file usbradio.conf. In rpt.conf, duplex= can be set to one of 5 different modes: Mode Description 0 Half duplex with no telemetry tones or hang time. Special Case: Full duplex if linktolink is set to yes. This mode is preferred when interfacing with an external multiport repeater controller. 1 Half duplex with telemetry tones and hang time. Does not repeat audio. This mode is preferred when interfacing a simplex node. 2 Full Duplex with telemetry tones and hang time. This mode is preferred when interfacing a repeater. 3 Full Duplex with telemetry tones and hang time, but no repeated audio. 4 Full Duplex with telemetry tones and hang time. Repeated audio only when the autopatch is down.