Take out one of the usb stanzas in simpleusb.conf and then check your rpt.conf for a matching rxchannel ie, either rxchannel = SimpleUSB/usb or rxchannel = SimpleUSB/usb28522 depending which you leave in simpleusb.conf -- Tim :wq On May 3, 2012, at 2:43 PM, David Kierzkowski wrote:
Also i am currently using
carrierfrom=no ctcssfrom=no for the below config was jsut from trying to find a working combination when posted the first msg..
On 5/3/2012 5:33 PM, David Kierzkowski wrote:
I have a ACID install with URIx connected to a icom v8000. Want to setup as a simple repeater. Through the portal when setting the interface to simpleusb, no PTT will work, but i can hear recieved audio. if i setup the interface as usbradio (i dont want / radio is doing ctcss/ speak level audio ) then the radio will PTT and pass overmodulated audio (as expected) but no RX audio will pass.
i have a feeling theres a config issue with simpleusb.conf.. do u guys see anything? I dont know why it creates the [usb] device stanza. Also while in the simple_tune_usb.sh i can see and set the RX levels properly and manually flash the PTT.
[general]
[usb]
hdwtype=0 rxboost=1 txboost=1 carrierfrom=dsp ctcssfrom=dsp txmixa=composite txmixb=0 invertptt=0 duplex=1 rxondelay=0 eeprom=0
[usb28522]
hdwtype=0 rxboost=0 txboost=1 carrierfrom=usb ctcssfrom=usb txmixa=voice txmixb=no invertptt=0 duplex=0 rxondelay=1 eeprom=0
and here is simpleusb_tune_usb28522.conf [usb28522] ; name=usb28522 ; devicenum=2 devstr=4-4 rxmixerset=400 txmixaset=500 txmixbset=500
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users