Ah yes... DIAL is a bit different than ACID. For DIAL I get Bus 001 Device 004: ID 0d8c:013a C-Media Electronics, Inc. and devstr=1-1.4:1.0 but this works also devstr=1-4 Don't know. Bob kk6ecm 73 _____ From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Steve Agee Sent: Saturday, May 21, 2016 2:05 PM To: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] usbradio_tune_xxxxx.conf where .conf =.confusion Yup, tried that early on with no luck. Then tried using the (W) command in both radio-tune-menu or simpleusb-tune-menu. The <bus>-<dev> listed in the tuning files does not match what the "lsusb" command reports. Well, the <bus> matches, but NOT the <dev>. On a working ACID install under same conditions, I have two (count them two) different tuning files where "devnum=3" go figure, and it works! N5ZUA On 5/21/2016 3:55 PM, kk6ecm wrote: run lsusb at the command line, then set devstr=<bus>-<device> for the device(s) shown. Your example is for Bus 004 Device 002. Bob kk6ecm 73 _____ From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Steve Agee Sent: Saturday, May 21, 2016 12:05 PM To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] usbradio_tune_xxxxx.conf where .conf = .confusion Hello list: I've searched <http://www.xelatec.com/xipar/node/180> <http://www.xelatec.com/xipar/node/180> and I fully understand the description/explanations given. What I don't understand, with specific attention to the lines: ; name=usb ; ; devnum=1 ; devstr=4-2 ; is how to manually uncomment, and manipulate them. In this particular instance, I'm trying to get a DIAL box running with one original URI (early version) using the USBRADIO channel driver, and one URIX (newer version) using the SIMPLEUSB channel driver. I've followed the step-by-step (or was that Crossbar 5 Duude?) instructions for starting off with a single node, then adding the second node. That simply doesn't work. The second URIx green L.E.D. stays solid throughout the process. Are these lines provided for informational purposes only, or can they be edited to force the second device to be recognized and assigned? N5ZUA _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.