No change... whenever I have ctcssfrom=no, the PTT on the URIx is active, and app_rpt won't take DTMF commands. When I switch back to ctcssfrom=usbinvert, all works normally, however, that configuration does not work with my substitute receiver. Thanks, Bob kk6ecm 73 -----Original Message----- From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of REDBUTTON_CTRL Sent: Sunday, May 22, 2016 11:21 AM To: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] RX Input Adjust Failed Comment out the ctcss tones listed. J On 5/22/2016 2:35 PM, kk6ecm wrote:
I discovered app_rpt does not like ctcssfrom=no. Why? (I'm using DIAL).
What am I missing?
Thanks, Bob kk6ecm 73
-----Original Message----- From: kk6ecm [mailto:kk6ecm@gmail.com] Sent: Sunday, May 22, 2016 10:37 AM To: 'app_rpt-users@ohnosec.org' Subject: RX Input Adjust Failed
What could cause the Error: RX Input Adjust Failed?
DONE tries=12, setting=1000, meas=58, sqnoise=13 ERROR: RX INPUT ADJUST FAILED.
No RF input to the radio.
I'm attempting to setup a substitute receiver for testing, but am experiencing difficulty setting it up, and not wanting to make a switch to simpleusb, thus making the minimum number of changes.
The substitute receiver (Yaesu FT-1500M) is detecting CTCSS, with USB COR out, and I'm using the speaker output. (see below conf file)
Any thoughts?
Thanks, Bob kk6ecm 73
from usbradio_tune...
hdwtype=0 rxboost=1 txboost=1 rxctcssrelax=1 txctcssdefault=107.2 rxctcssfreqs=107.2 txctcssfreqs=107.2 ;rxctcssoverride=0 ;carrierfrom=dsp carrierfrom=usb ;dsp ctcssfrom=no ;usbinvert rxdemod=speaker ;flat txprelim=no txlimonly=no txtoctype=notone txmixa=composite txmixb=no invertptt=0 duplex=1 rxondelay=0 rxnoisefiltype=0 eeprom=0
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.