This really should be in the instructions somewhere - but, basically, you follow the instructions for a two node system (could be followed for N nodes actually) http://app-rpt.qrvc.com/node/49 the trick is pick a node number <1999 and follow the instructions except do *not* put in the entry for iax.conf and in the [nodes] section not the node section (!) you have two types of entries possible example [nodes] 1625 = radio@192.168.1.109/1625,NONE ; 27061 = radio@127.0.0.1/27061,NONE ; the one with radio@127.0.0.1 says to go look up that node's address in a file that gets downloaded from the allstar server the one with radio@192.168.1.109/ says to use this specific and forever unchanging address for that node. Of course, you fill in your own particular box's IP address If your router changes the node number of your box, this will stop working. I have a UPS on my router. GL Ken 27021 (web transceiver and internet streaming audio too) 27061 and my private node: 1625 (162.55 NOAA weather radio) -----Original Message----- From: Bob Brown - WØNQX <bbrown@byrg.net> To: Ken <ke2n@cs.com> Sent: Sun, Jul 18, 2010 5:47 pm Subject: Re: [App_rpt-users] internal node: FINALLY so now that this is done can you recap with examples of what was done? i wish to do the same here on one of my systems -- Thanks in Advance Bob Brown, WØNQX Kansas City Metro Area http://sm0kenet.net http://byrg.net http://kcdstar.byrg.net Quis custodiet ipsos custodes? On Sun, Jul 18, 2010 at 16:40, Ken <ke2n@cs.com> wrote: > Thanks Steve for putting up with my mental density > > Conclusion: > > The IP address does not go in the node stanza > > It goes in the [nodes] stanza (further down the page). > > And it works. > > > Ken > > Sigh > > > > > _______________________________________________ > App_rpt-users mailing list > App_rpt-users@qrvc.com > http://qrvc.com/mailman/listinfo/app_rpt-users >